
Buoyancy you can control.
A helium envelope sets the lift, a ballonet inside it changes the vehicle's density, and a hinged arm shows the result.
Inflate the ballonet.
Drag the slider. The ballonet fills with ambient air, buoyancy shifts, and the arm lifts the aerobot, up to 15–20 cm. The numbers come from the proposal's design values.
- Arm angle
- 0°
- Rise vs gondola
- 0.0cm
- Buoyancy change
- 0.00g
Deflated · arm at 0°
Illustrative and not to scale in time. The real arm response is exactly what the flight will measure.
Five parts, one measurement.
Helium, sealed
A thermoplastic polyurethane (TPU) envelope, nominally 50 cm across at float. No gas is exchanged in this volume during operations. The helium fill is sized to allow for expansion on ascent.
Air, adjustable
An inner TPU bag sized for about 10–12 L of ambient air at full inflation. It inflates and deflates to change the aerobot's relative density.
On the beam
A volumetric pump feeds ambient air to the ballonet. It sits on the fixed beam, which keeps mass and vibration off the moving arm.
A 50 cm beam, a hinged arm
A fixed beam leaves the gondola. At two-thirds of its length a 15–20 cm arm swings from 0° to 90°. A precision actuator at the hinge cancels the dry mass, because lift at float is only about 3 g.
Inside the gondola
The flight computer and data acquisition system sit in the main experiment module, protected from the stratosphere. All power comes from the BEXUS gondola supply.
Venting and restraint
The ballonet venting method and the arm restraint for launch and descent are not yet defined. We will publish them once designed and tested.
What we record, and how.
| Quantity | Sensor | Why |
|---|---|---|
| Arm angle | Rotary or magnetic encoder | Converts to the aerobot's displacement relative to the gondola. |
| Pressure | Ballonet · helium · ambient | Differential pressure between injected air, helium and the atmosphere. |
| Temperature | Thermocouples or RTDs | Thermal gradients across air, helium and ambient, especially at the tropopause where temperatures can fall below −80 °C. |
| Motion | Nine-axis IMUs | One on the gondola, one on the aerobot, to separate disturbances from the control response. |
An arm that can never become a hazard.
The gondola is shared with other experiments, so the external arm is designed to fail safe.
- Sacrificial jointThe arm yields or decouples on a hard landing, protecting the gondola and neighbouring experiments.
- Safety tetherSecures the arm to the gondola frame so nothing becomes an untethered hazard.
- 0° restraintHolds the arm during pre-launch handling, ascent and descent. Mechanism still to be designed.
- 90° hard stopStops the arm from swinging past vertical toward the gondola, other experiments or the suspension cables.
- Load testsStructural and load tests before flight for up to 10 g at parachute opening and landing loads.